Revcon Forums
https://www.policeinterceptor.com/revconforums/

Front Suspension Interchange Flat vs Slant
https://www.policeinterceptor.com/revconforums/viewtopic.php?f=4&t=130
Page 1 of 1

Author:  wimpy88 [ Fri Jun 23, 2017 12:42 am ]
Post subject:  Front Suspension Interchange Flat vs Slant

Could we get a confirmation of whether the front suspension pieces are interchangeable between the older & newer Revcons?

I presume (cause ain't going to assume) they use the same bits & pieces since the Toronado was the donor front end. Which also begs the question: Was the Eldorado FWD the same front suspension as well?

Author:  Daveinet [ Fri Jun 23, 2017 1:29 pm ]
Post subject:  Re: Front Suspension Interchange Flat vs Slant

While the concept of the front suspension was somewhat similar, there are no shared parts between the two that I am aware of. The slant nose front end is rated for 1000 lbs more than the Toro. This means virtually every part is heavy duty than the Toro. Most of the wear parts are common to other vehicles, you just need to either ask specifics, or take the part to your local parts store and see if they can match it.

Author:  wimpy88 [ Sat Jun 24, 2017 3:32 am ]
Post subject:  Re: Front Suspension Interchange Flat vs Slant

Thanks for the clarification. Much appreciated.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/